BOOSTER 60 – Booster60 is a thermal flywheel that plays an essential role inside a heat pump central heating plant. It is an ultra compact container to be installed in series between the heat pump and heating/cooling distribution system. Booster60 allows you to save the energy produced and reuse it later when the heating system is not in operation, obviously saving on the heating/cooling costs for the building.

PROVIDES THERMAL INERTIA TO THE SYSTEM, INCREASE THE EFFICIENCY AND LIFE OF THE HEAT PUMP.
A Heat Pump’s life and performance are influenced by the number of on/off cycles. Booster60 optimises the heat pump’s operation, minimising the ON/OFF cycles. Booster60 allows the Heat Pump to work for long enough time intervals to reduce the number of on/off cycles. In the same way, the accumulated thermal energy temporarily suppresses requests from the distribution system while the machine is not working.

GUARANTEES THE HYDRAULIC SEPARATION OF THE FLOWS BETWEEN THE HEAT PUMP AND DISTRIBUTION SYSTEM.
Booster60 allows the heat pump-side circuit and the system-side circuit to be made independent of each other, optimising the work of the circulation pumps and thus allowing the heat pump to work efficiently. Its interior design was studied to perform the functions of hydraulic separator and distribution manifold for 2 system zones.

ALLOWS THE DEFROSTING IN AIR/WATER HEAT PUMPS TO BE MANAGED WITHOUT DECREASING THE COMFORT INSIDE THE BUILDING.
Booster60 can be used in both heating and cooling systems. In the latter case, installation of the Booster60 prevents the danger of a decrease in comfort (especially in the case of fan coil units) even during the defrosting cycles of evaporators in most air/water heat pumps.

BENEFITS

• Less machine wear
• Thermal energy management optimised
• Operating cycles optimised
• Custom solution
• Reduction in compressor start-ups
• Heat pump operating at full capacity
• Improvement in plant performance

SPACE-SAVING SOLUTION
Super compact 240x520x860 mm with wall installation